Schatzie
04-24-2006, 01:45 PM
My NP231 t-case is bad, I have not cracked it open yet to see what is wrong but the folks down at Hooze 4x4 (local Shop)tell me my chain is sliping. SO... I posted on a local web site on this issue and some from that site has a NP 208 which has a yokes for both rear and front drive shafts, I can kill two birds with one stone, replace the old t-case and get 1/2 of what I need for a complete SYE. (still need a Drive shaft)
So currently the plan is to swap the 208 for my current 231. Now there are couple of issues.
1. I have AX-5 tranny and the 208 that I have came from an auto tranny- SO the input shaft on my 231 is 21 spline and the the 208 input is 23 spline. The question is can I take the input shaft out of mine and install in the 208?
2. Since I have NEVER taken apart ether of these cases, where can I find a manual or a step by step to taking both of these cases apart?
Thanks folks...
Newbie note: Please keep in mind that I started this whole fix your own s##t 4 years ago with replacing my first water pump. So I'm learning as stuff breaks..
So currently the plan is to swap the 208 for my current 231. Now there are couple of issues.
1. I have AX-5 tranny and the 208 that I have came from an auto tranny- SO the input shaft on my 231 is 21 spline and the the 208 input is 23 spline. The question is can I take the input shaft out of mine and install in the 208?
2. Since I have NEVER taken apart ether of these cases, where can I find a manual or a step by step to taking both of these cases apart?
Thanks folks...
Newbie note: Please keep in mind that I started this whole fix your own s##t 4 years ago with replacing my first water pump. So I'm learning as stuff breaks..