Hi all
I need some help trouble shooting my abs on my 2000 rodeo . the light is on az cannot read the codes. Can I check wheel sensor with a volt ohm meter?

What are your symptoms? Let me know and I can see if I can run the symptoms through the chart in my manual and try to help without a Tech2.

I think you can jump the ABS codes in the data link connector (jump the Ground and ABS, I'm not sure the terminals of a Rodeo, on a newer Trooper they are #12 and #4 or #5). Code 12 is user interface and will blink 3 times. Then it'll display the next set of codes in the order they were stored. Here's a list from the Trooper, they might be the same for the Rodeo.

Code - Item - Diagnosis
12 Start Code Normal
14 EHCU Function Abnormality in input/output, operational and control
circuit
15 Power Voltage Drop
16 CLASS–2 Communication Line Abnormality
21 G-sensor Wiring disconnection
23 Transmission Input Input abnormality
24 Transfer Monitor
32 Motor & Motor Relay Shorted or disconnected coil
35 Valve Relay Shorted or disconnected coil/wiring
41 FL Holding Solenoid Valve Shorted or disconnected coil/wiring
42 FL Decompression Solenoid Valve Shorted or disconnected coil/wiring
43 FR Holding Solenoid Valve Shorted or disconnected coil/wiring
44 FR Decompression Solenoid Valve Shorted or disconnected coil/wiring
45 Rear Holding Solenoid Valve Shorted or disconnected coil/wiring
46 Rear Decompression Solenoid Valve Shorted or disconnected coil/wiring
51 FL Wheel Speed Sensor Disconnected coil/wiring
52 FR Wheel Speed Sensor Disconnected coil/wiring
53 RL Wheel Speed Sensor Disconnected coil/wiring
54 RR Wheel Speed Sensor Disconnected coil/wiring
61 FL Wheel Speed Sensor Shorted coil/wiring
62 FR Wheel Speed Sensor Shorted coil/wiring
63 RL Wheel Speed Sensor Shorted coil/wiring
64 RR Wheel Speed Sensor Shorted coil/wiring
65 Sensor Signal Input Wrong number of teeth

Thanks for the help
The abs light is on and the brakes work as normal brakes .no abs
Chris

Check your PM