Fresh rebuild less than 6 months ago and one trail ride on it since then. Heavy duty front and rear outputs. 1350 flange on the back and a 1350 yoke on the front that has been clearenced a bit to allow for a little more angle. Case was beadblasted before fresh paint was added. Advance Adapters clocking ring/spacer is also mounted and ready to go.

$700

This is located in Thornton, CO.

http://img.photobucket.com/albums/v333/sthede/done2.jpg

Bump

maybe if shipping was included

PM sent in case you change your mind about shipping.

Bump

Is the front 1350 yoke standard or for cv shaft?

Do you still have this? I assume since you had it mated to an AX-15 that it will mate up to my NV3550 w/ no problem.

Let me know,

Mike