DIY4X
05-14-2006, 10:27 AM
Here's a piece we did up yesterday.
Couple things to note though. I will be trimming down the bridge supports to make for more clearance.
These will be supplied with GRADE 9 Hardware. 7/16" bolts, pinch lock nuts and washers.
http://www.diy4x.com/photos/axle_clamp2.JPG
http://www.diy4x.com/photos/axle_clamp.JPG
Everything you see here is 1/4" thick material. The tubing is DOM.
From here we will be moving into a bolt on shock mount for our Shock mount inboarding kit.
We will also continue development on our Bolt on Truss/antiwrap system which by the way isn't far off.
Soon as I can get some figures together we'll get these on the website.
Couple things to note though. I will be trimming down the bridge supports to make for more clearance.
These will be supplied with GRADE 9 Hardware. 7/16" bolts, pinch lock nuts and washers.
http://www.diy4x.com/photos/axle_clamp2.JPG
http://www.diy4x.com/photos/axle_clamp.JPG
Everything you see here is 1/4" thick material. The tubing is DOM.
From here we will be moving into a bolt on shock mount for our Shock mount inboarding kit.
We will also continue development on our Bolt on Truss/antiwrap system which by the way isn't far off.
Soon as I can get some figures together we'll get these on the website.