SOA conversion

[Matth_85]

I am in the middle of a low budget SOA conversion. I am looking for a place to purchase the pasengers side spring perch for a Dana 30 front axle, or someone with some good advice on fabrication. I bought the jeep with the rear done and im in the process of doing the front. I have the drop pitman arm, and pretty much everything else i need so im just looking for a place to get this hanger or some fab. ideas.

[gatorpsd]

2" or 2.5" wide springs. There r tons of place that sale the pair for 20 buck or not much more.

[Matth_85]

they are 2" springs. What are some websites if you know them right off?

[Infernal Jeep]

they are 2" springs. What are some websites if you know them right off?
Just go to 4 wheel parts or some place that sells 4x4 accesories and products and they should have them.

[LCAC_Man]

It would be pretty easy to fab but if you want to buy it give this guy a try, he might seperate pieces from his kit and he list an "offset" perch so it may be just what your looking for.
http://cgi.ebay.com/ebaymotors/Free-Shipping-Jeep-CJ-1976-Spring-Over-Conversion_W0QQitemZ8064754630QQcategoryZ33585QQss PageNameZWDVWQQrdZ1QQcmdZViewItem

[Bone Down]

I am in the middle of a low budget SOA conversion. I am looking for a place to purchase the pasengers side spring perch for a Dana 30 front axle, or someone with some good advice on fabrication. I bought the jeep with the rear done and im in the process of doing the front. I have the drop pitman arm, and pretty much everything else i need so im just looking for a place to get this hanger or some fab. ideas.


Sweet, thanks Kurt.

:edit: the actual part number as far as Chrysler is concerned is P4120074, in case anyone wants to know. And they're $8 a pair!

This guy is doing the an SOA and asked this same question just recently, have a look at the original post.
(http://www.rockymountainextreme.com/showthread.php?t=33250)

[DevinB]

This guy is doing the an SOA and asked this same question just recently, have a look at the original post.
(http://www.rockymountainextreme.com/showthread.php?t=33250)

That's me. The problem I found out AFTER I ordered them is that the hole for the spring pack bolt is too big and will allow your spring to move around. It's discussed here:

http://www.rockymountainextreme.com/showthread.php?t=29632&highlight=perch

I'd look around. Foothilloffroad.com sells a bunch that you can use.

Devin

[Matth_85]

Thanks for the help, finished up the front today. Wound up just fabing one up today.

[resqme]

FWIW, MORE (http://mountainoffroad.com) sells a high quality anti-wrap version of this mount.