I have an 89 s10 blazer with a d30 SFA that is spring over, I have a 4 drop pitman arm, and my problem is the drag link, I hope to this summer have a hy steer setup similar to the one built by MORE, but until then I have a drag link that I built with two Jeep tierods, and I slide them into a small piece off DOM, my tie rods are bent (from torch) and flex under a load with the 33s, I was thinking, If I use thick walled 1in DOM and have it bent with a bender, do you think this will be strong enough to not flex and such under a load? I ask because funds are tight and this length of DOM is goin to be near 45 bucks, and I dont want it if aint strong enough to cure my problem, like I said this is to get me by until I can get the hysteer setup goin. :confused: