|
MillerMan 04-15-2002, 07:58 PM Talked to the neigbor tonight and he has a Turbo 350 out of a mid 70's Buick Car. Says it has a "universal" bellhousing to bolt up to my Chevy 350 out of my Suburban. Will this work and what type of adapter do I need for the ouput? This is going into a lengthened CJ-5 with my np208 transfer case! I did SEARCH for "TURBO350" and didn't find much!!! :beer: :beer: :beer: ForestCam 04-15-2002, 08:00 PM If it's a uni-bolt case all you'll need to do is swap out the output shaft. MillerMan 04-15-2002, 08:16 PM Sorry ForestCam, but if it is an Agricultural related question I will rattle off answer's all day long, but Transmission chit needs to be black and white for this cat. Replace the output shaft with one for a ????? I would assume 350 auto in any four wheel drive application, is this correct? The guy wants $100.00 for it and absolutely guarantees the thing! :beer: :beer: :beer: MillerMan 04-16-2002, 05:37 AM Good, bad, or indifferent, Someone enlighten This FAWKIN NEWBIE!!! :beer: :zzz: :beer: morpheus 04-16-2002, 07:27 AM you need to replace the output shaft from the T350 2wd vehicle with one for a 4x4 T350. you can either pick one up used or Advanced Adapters sells them for about $75 or $80 ... good luck. - jack Grandpa Jeep 04-16-2002, 07:57 AM What did the transfer case come from? Was it originally behind a TH350 or TH700? I think the GM 208 has a different spline count for TH400 and SM465 applications. It might work with a factory GM adapter though, count the splines on the NP208 input and TH350 output. If it doesn't you will have to swap the output shaft for one that will. POS w/Potential 04-16-2002, 08:07 AM As far as bolting it up to the engine is concerned, you need an adapter plate, which I belive advance sells, but would be extremely to duplicate cheep if you had one to look at. (only 3/16" or !/4" plate with a few holes drilled in it. Grandpa Jeep 04-16-2002, 12:32 PM Originally posted by POS w/Potential As far as bolting it up to the engine is concerned, you need an adapter plate, which I belive advance sells, but would be extremely to duplicate cheep if you had one to look at. (only 3/16" or !/4" plate with a few holes drilled in it. No you don't, not if it's a dual pattern case. It will bolt up to either a Chevy or a BOP engine, nothing else is required. | |