PDA

View Full Version : NP203 clocked UPSIDEWN pissing lub

Larry
06-04-2006, 11:46 AM
Well was going to do a search but it seems to be GONE for now SOOOOO~~~ I have an NP203 splitter box clocked UPSIDE Down in my Zuk and it's Pissing all the lube out the Vent tub. I tried moving it to the other side(drivers) but it did the same thing. I have installed an overflow tank on it and am hoping it will catch the lobe and then when I stop it will drain back in the case. Haven't got to try it since I installed it as I had to hit the Road right after I got it done(drive a truck for a living). Was just wondering if any one has a "FIX" for this problem.
Hvy_Chevy
06-04-2006, 12:11 PM
google:

clocked np203 site:http://www.pirate4x4.com/forum

go forth and search young grasshopper
Pietro
06-04-2006, 12:36 PM
the fact that you have a 203 in a zuk is a little fucked up:laughing:
Larry
06-04-2006, 03:33 PM
the fact that you have a 203 in a zuk is a little fucked up:laughing:
http://s26.photobucket.com/albums/c114/lrfrew/th_CID__Picture0151.jpg
Not realy I just have the splitter box off of the NP203. Then a dana 300 T/C
http://s26.photobucket.com/albums/c114/lrfrew/ZUK%20CONVERSION/th_2.jpg
This is the drive train befor I clocked the NP203 upsidedown
Jy Dog
06-05-2006, 09:14 AM
google:

clocked np203 site:http://www.pirate4x4.com/forum

go forth and search young grasshopper



Did you even READ the beginning of his post? :rolleyes:

He said the SEARCH was down.....

Back to topic....

We have tried even running a longer vent tube inside of the 203 box to try and get out of the oil flow from the gears spinning. Still pissing gear oil out the vent, although, not as bad.

Any suggestions or thoughts would be welcome....

:evil:
SSLT1KID
06-05-2006, 08:54 PM
i think heavy chevy was implying that he should use www.google.com to search www.pirate4x4.com . at least thats what i got from it.
Jy Dog
06-06-2006, 09:22 AM
i think heavy chevy was implying that he should use www.google.com to search www.pirate4x4.com . at least thats what i got from it.

Okay...I didn't get that.....

No problem, though.

Larry put a tank up above the np203 and ran the vent to the bottom of the tank and an air vent out the top of the tank.

This seems to be working pretty well so far. We road tested it last night and it wasn't blowing out the vent tank, nor was it filling up the vent tank, so hopefully he will be good to go.

Thanks guys!