I am working on a SAS project using a 78 ford HP Dana 44. The axle is completely disassembled, and I don't have any of the original steering. I am planning to build the steering out of 1" ID 1.5" OD DOM. Trying to decide whether or not I have enough to do it.

I'm also using 7/8" TRE's, the common ones for a steering setup like this.

What is the length of the stock tie rod, drag link, and track bar?

I am using Waggy knuckles, so I would assume that would change the overall width by a little.

HAHA This is the 8000th thread in this forum. What a privilege.

I just did a little math and guesstimating after taking some measurements, I think the tie rod should be about 59", is this correct? If so my drag link will need to be 44.5", and I have enough DOM to do it! woo wooo!