help me jeep boys im gona throw a dana 300 in my suzuki iwas hoping some one might kno if there is a flange kit to replace th yokes on the front and rear outputs i have a plan to make some but if they can be purchased it would free up some of myy time for other work :smokin:

High angle or any big driveshaft shop can hook you up. Check the vendors section.

Isuzu rodeo uses a flange on the rear axle.... the rear axle is a d44.... which is the same spline count and size as a stock d 300.... go to the junk yard and try to score a couple... also look under honda pasport (sp?)

Early XJ's (84,85, and maybe 86) used funny looking "stick in a Beer can" CV joint ft driveshafts.
These ft driveshafts bolted to a flat flange on the ft output.

I don't know if it'll work for what you want it for (it's a pretty small patturn flat flange, but there may be enough room to drill a Sammi patturn), but the yoke will fit ft & rear (stock) D300 outputs.

It's one of those parts no one wants, on a T-case no one wants, so if it works, it ought to be cheap.

sweet guys ill be hitten the bone yard this weekend by the way im running toy shafts not sami

sweet guys ill be hitten the bone yard this weekend by the way im running toy shafts not sami

Jessi from high angle driveline sells a bolt on Toy flange for the d300. They are VERY nice and work perfect.

I think they are around $99, give him a call :smokin: