: Ford D44 Shafts & Outers


zainyD
07-11-2006, 04:17 PM
I need to clean off my back porch so here goes. I'm in Florida and buyer pays shipping in most cases. I can ship, by UPS or USPS.


Ford Dana 44 Parts

Full width axle shafts: $100+shipping for a complete set of inners and stub shafts. I have two complete sets for sale if someone needs trail spares.

I will also sell the shafts individually if you don't need a complete set.

Ford D44 5-lug outers: knuckles, spindles, caliper brackets, calipers(cores), and some misc hardware. Perfect for disc brake conversion on a drum brake axle $150+shipping

All parts are in good, usable condition. If interested please PM me, thanks.

zainyD
07-12-2006, 04:59 AM
Bump, prices are negotiable.

XJ_ranger
07-12-2006, 07:45 AM
"full width" ?

Like F250 full width or like f150 full width?

'cuse I Need a long side inner for a d44 - full width from a 76 f-150...

so an axle shaft from a 73-79 F-100, F-150, or Full size bronco would do it for me -
33-29/32" from end of the splines to yoke center for a 760/297 joint...


If you have this - Ill take a set for 100 shipped?

ricesyj
07-12-2006, 03:38 PM
If these ar from an F150 73-79 Dana 44 I will take a set for $100 shipped also.

zainyD
07-13-2006, 05:51 AM
Yes, the shafts are from Full-Width F150's. I need both of you guy's zips so I can figure out shipping.

Thanks.

InstaGator
07-13-2006, 08:29 AM
where in Fl are ya?

zainyD
07-13-2006, 09:26 AM
Central Florida, Lakeland, to be exact.

zainyD
07-14-2006, 03:37 PM
Both sets of axle shafts have been spoken for...

jeeperak
07-30-2006, 02:05 PM
how about the spidles??

85635

RSQJEEP
07-31-2006, 06:15 AM
Do you still have the F-150 knuckles for sale? I need a driver's side.

BeerStud
07-31-2006, 02:52 PM
Any pics of the 5 lug stuff?

zainyD
07-31-2006, 06:59 PM
Sorry, I haven't been keeping up with this thread.

jeeperak, the spindles are yours.

RSQjeep, I have the driver's side knuckle, but I think one or both of the balljoint holes has become worn to the point that it will not securely hold a balljoint. If you still are interested LMK.

BeerStud, sorry no pics.

RSQJEEP
08-01-2006, 10:42 AM
Thanks for the reply, but I will pass. Got the same issue going on here too.

zainyD
08-02-2006, 06:15 AM
Ok, thanks though.