|
gateway 08-07-2006, 05:45 PM What's the setup to get the 9 inch to the stock CJ7 driveshaft. u-joint? yoke? Putting the finishing steps into bolting the 9 to 1983 wide track. Steve jeepcj75 08-07-2006, 07:39 PM Well depending how much lift your running, i know for a fact that a stock cj7 driveshaft wont bolt up to a 9 inch in a spring over. if you keep the lift small it should bolt up.:D brian4wd 08-07-2006, 07:58 PM U-joints with diff sized cap diameters - Ford on side, Jeep on the other. Can't remember the Spicer P/N but I have them in the front and rear of my '79 CJ-7 due to the Currie axles. Brian | |