I am just finishing my hi-steer install on my 85 toyota.

My Problem:
One of the two lines that go into the ps box wont go in at all. The high pressure one has gone in just fine but the smaller line of the two wont even thread one full turn. :shaking: Any tips? I dont think the fitting is stripped, but I cannot be sure of the box. Wouldnt the fitting get mangled before the box??

Second, the steering line that comes from the engine goes on the left hand side of the box if you are looking at it from the top right?

Thanks!!!

:flipoff2:

the return is the inside port, the motor side.

the feed or hi pressure line is the outside one, or the wheel well side.