knmhoffman44
08-21-2006, 10:14 AM
New springs, never used (or installed). The following description was taken from www.trail-gear.com. $400 for the whole set (front and rear). Email with any questions. Located in Oakdale, CA (near Modesto) and would prefer not to ship. Will ship, but buyer to pay actual shipping costs (no extra "handling" charges) and I will research to get the best price for you. Will also deliver if close enough, or if you want to meet "in the middle" and it isn't too far.
Thanks!
Front Springs
feature a full military wrap on the front and the 1/4 wrap on the rear. Spring rate is 220 lbs per inch. Leaf pack is 6 leaves. Springs are 47" long as measured along the top leaf. Pin to center of front mount is 22" and pin to center of the shackle mount is 25". New polly bushings and left side spring pad are included with springs.
Rear Springs
feature a full military wrap on the front and the 1/4 wrap on the rear. Spring rate is 235 lbs per inch. Leaf pack is 7 leaves plus a special torque leaf to reduce axle wrap. Springs are 56 5/8" long as measured along the top leaf. Pin to center of front mount is 27 1/2", pin to center of rear mount is 29 5/8". New polly bushings are included with springs. These springs are longer than stock and will require hanger relocation
Thanks!
Front Springs
feature a full military wrap on the front and the 1/4 wrap on the rear. Spring rate is 220 lbs per inch. Leaf pack is 6 leaves. Springs are 47" long as measured along the top leaf. Pin to center of front mount is 22" and pin to center of the shackle mount is 25". New polly bushings and left side spring pad are included with springs.
Rear Springs
feature a full military wrap on the front and the 1/4 wrap on the rear. Spring rate is 235 lbs per inch. Leaf pack is 7 leaves plus a special torque leaf to reduce axle wrap. Springs are 56 5/8" long as measured along the top leaf. Pin to center of front mount is 27 1/2", pin to center of rear mount is 29 5/8". New polly bushings are included with springs. These springs are longer than stock and will require hanger relocation