|
Jkrause 09-08-2006, 03:19 PM dumb question I know but I've never done it before.... 1.25 / .120 wall sleeved with 1.5" /.120 wall USE WD-40 and a BFH ????? How hard will this be to hit together ?> JEff gumbojeepyj 09-08-2006, 04:04 PM think about this for a second..... 1.5" x .120 wall will have an ID of 1.26" it'll slip right in.... that's one good reason why it's .120 wall and not .125 wall. Jkrause 09-08-2006, 04:11 PM then will I have to weld it together to use a lower piece in a ladder bar ? Again I feeeeeeel Reallllly Stoooopid gumbojeepyj 09-08-2006, 04:13 PM yeah you can plug weld it.... cut the 1.5OD tube just a bit shorter (1/4") to get a nice weld fillet on teh ends... Jkrause 09-08-2006, 04:15 PM THANK DUDE....... 1 for not ripping me a new A hole an d2nd ... for the advise. ! Jeff Jkrause 09-08-2006, 04:17 PM THANK DUDE....... 1 for not ripping me a new A hole an d2nd ... for the advise. ! Jeff But hte lower bar of a traction / ladder bar getr pretty aggresivly cotched..... just filet the bushing mount side ?? leave the big ass notch alone ??? | |