hi, picked up a dodge dana 60 front dirt cheap but its the shitty 30 slpine inners no locking hubs and to piece tubes. i wanted to see what guys on here were doing with those if anything at all. i was thinking about replacing the carrier with a 35 slpine unit and getting new oem shafts from something else to mate to the 32 slpine outers. they should be strong enough for what i need. i also wanted to retube it to get rid of the one piece tubes and narrow it, is there any reason this wont work? any opinions and thoughts are apreciated. thanks

i maybe stupid here but i didnt think they made a 60 wit ha 2 piece tube.......i know dodge had a d44 that had the 2piece i believe........

if it is a 60 i dont see where what you talked about wont work

You can swap out the carrier for 35 spline shafts.
Also I would get rid of the Unit bearing hubs, I think there are companies (dynatrac for sure) that makes conversion kits to get rid of the unit bearing, and go to a 35 spline outer.