|
: Heat sending unit location-'02 5.3 Vortec? CAROLINACRAWLER 10-25-2006, 07:39 PM Looked thru archives with no luck- Can't find a place to connect mechanical temp. gauge to an '02 GenIII 5.3. I guess i could make a place in line with top hose but had rather not. Any help? thanks CAROLINACRAWLER 10-26-2006, 04:31 AM ttt Bo185 10-26-2006, 07:42 AM Why not just use the stock electric sender in the drivers side head at the front, or remove it and put the mech. one there at that location. Its a metric threaded hole. CAROLINACRAWLER 10-26-2006, 07:43 PM Why not just use the stock electric sender in the drivers side head at the front, or remove it and put the mech. one there at that location. Its a metric threaded hole. That's the info i've been looking for- thanks Bo185 10-27-2006, 02:16 PM That's the info i've been looking for- thanks What's it going into? CAROLINACRAWLER 10-28-2006, 10:18 AM What's it going into? Already in! :D bigS-dime 10-28-2006, 11:21 AM there is also a boss in the water pump area at the front you can drill and tap easily. That is what I did, i'll try to get a pic later CAROLINACRAWLER 10-28-2006, 03:02 PM there is also a boss in the water pump area at the front you can drill and tap easily. That is what I did, i'll try to get a pic later A pic would be great, I have it in 1 of the heater outlets of the pump but i'm not so sure i'll get a true reading there. Can't seem to come up with a "t" fitting to use the orginal location. My Howell harness has a plug for it so i hate to completely do away with the stock 1. I'm not sure how the computer react w/o that reading. | |