DOUG38S
11-07-2006, 11:45 AM
I have a set of dodge 60's with stock 4.88's that are open/open. Front hubs were chevy dually and the hubs were machined down to single wheel. I have new lug studs and a kingpin rebuild kit for the front. Front axle was received from High Honda last year and never used for my project. Both axles are set up for spring over and are currently under my tj project. Shafts are 30 spline outters with 35 spline inner and has 30 spline lockouts. Can help with delivery towards Tn or PAP in the next couple of weeks.
1000$
DOUG38S
11-13-2006, 11:06 AM
anyone intersted in a rolling package?
RoKAHype
11-14-2006, 04:50 PM
how much for the front if you want to split? and what side drop
DOUG38S
11-15-2006, 06:42 AM
I'd take 850 for the front. That's what I paid from Highhonda and this axle has never been used.
fbpd227
11-16-2006, 01:22 PM
What year are they out of? Sounds like what I might be needing for my YJ project. Not too familiar with the Dodge stuff though? Wider spring spacing than Chevy or Waggy's? Whats the wms to wms width front and rear?
DOUG38S
11-17-2006, 08:11 AM
The dodge and chevy spring widths are within a .5 inch of each other. Not even noticable. The WMS is either 67 or 69 I cannot remember.
blasphemous
11-21-2006, 02:47 AM
What's the spring pad spacing on the front axle? I'm wondering if it'd be a direct swap for a 79 GM 10-bolt as far as leaf springs are concerned.