|
GBRAVO 05-06-2002, 12:52 PM Somobody knows how many degrees do I have to turn up the front 3rd member to relocate it straight to T case, considering 7" off lift on SPOA set up? Somebody tryed to do it by cutting the center section of housing instead of the knuckles? onetoncv 05-06-2002, 10:00 PM i'd say about 12 degree's would be in the park- :D -Jess billj 05-07-2002, 07:40 AM Get off your duff, climb under the truck with a tape and take a few measurements. Then do a little math, IF you know how... FawkinŽ South American newbie...:flipoff2: :flipoff2: ========= J/K, IŽm also a SA newbie...:p But IŽm serious about the measurement part. That and a few trigonometry calculations and youŽll be real close to getting it right... HTH, ROCKILLER 05-07-2002, 09:53 PM nah thats too much work. get everything cut for the rotation and then bolt the axle up. then use somethind straight and point the pinion at the t-case flange. okie injuneerin all the way | |