I just put in my dana 300 with the teraflex 32 spline rear output shaft. But I didn't realize that this kit comes with a CV yoke for the output. Does anyone have a spicer part # for the 1310 non-cv 32 spline yoke or no where to look for this?

stak, high angle driveline, Tera flex, local driveline shop ect ect.

It will work for non-CV as well.
You just have to tap the ubolts a little bit to get them through.
Very commonly done because that is a mass produced yoke, I believe for a NP241(?).
The non CV yoke is much more expensive for the kit producers to aquire.

I had the same/similar problem.
$40 at the driveline shop for the correct yoke, and more $$'s to shorten the drive shaft and was back on the trail. It looked like a "blended" version of two yokes, so it was about 1.5" longer thus the need for a shorter drive shaft.
I can't post a photo on this site but I'll PM you or post

I have a 32 spline non-cv yoke from AA I'll trade you! If you're interested send me a pm.