I have a upper hoop that follows the side of a 84-89 toyota (orignally made for a 4runner), curves at the A pillars, and then again at the front of the windshield. Made out of 1.75" HREW.

Asking $60, or best offer, as I need more room in my garage.

Located in Morgan Hill, Ca

pic

How about $40?

btt

Btt. Obo

only have one of these?

Yup, only one. Made it for my exo, then bought an internal cage.

I do have another piece with 3 bends in it, i will give you for free though.

can you send me pics of both im very interested? could the other piece be made to be the other side? i dont have bender. Im in hayward so iam close to you. you ever get closer to the bay area??

Do you mean the rear half of it? I dont quite get what you mean by the other side. This hoop is for the top of the truck. The other hoop is identical, but about 4" narrower (a screw up), and one side I cut down, and used the tube somewhere else.

No I dont get any further north, nor will this thing fit in my 4runner, short of strapping it to the roof.

Basically, this upper hoop, is copied off of this truck:

I see now. Im a visual learner!!!!. ok let me see when I can get to you. matbe next week. im in medic school right now and my time is very hard to manage.

btt

BTT. Get this gone!

btt

sorry I have been busy I need to find time to come see you about this, If you find another buyer by all mean sell but If I can find time soon ( 6 more 24 hour shifts 2 days aweek til I finish medic school!!!) then I will come get this from you! sorry for the delay

ttt

btt

btt

btt

btt