I am looking for a fairly strong tcase with a front AND REAR driver side drop. I know I have seen them around but I don't know how strong they are. I want the offset because I am running 2 short side shafts in my rockwells and would like the d-shaft to run sort of straight.
Any info would be appreciated.
Thanks

Here is a pic of my offset.

http://memimage.cardomain.net/member_images/12/web/2232000-2232999/2232056_22_full.jpg

Do you guys think I could run a driveshaft at that angle? The rear axle will be about 10 inches further back than the stock location.

I thought there was a way to flip the third around? If not, I believe np200's have the offset you're looking for.

I can flip the third around but my diff is centered so it would just end up on the other side.
Thanks, I'll check out the 200s

I can flip the third around but my diff is centered so it would just end up on the other side.
Thanks, I'll check out the 200s

then you could use a stock Quadratrac setup and everything would line up.

i would do some calcs and angle measurements, it looks like it would be within 1350/1410/1480 spec angle.


how long would your rear shaft be?
what is your wheel base?