I am getting ready to go wheeling, and I need to know what spare parts to carry. What do you guys usually break uot there? I am running a 1977 Bronco with F150 RC44 front and 31 spline 9" rear, 302, Dana 20, 36's. What spare parts should I get for this truck? I know aobut the Dana 20 output shaft, but what else? Also where can I get some 20 outputs?

Dimitri

That and front axles,
If you running stock f150 steering, per pare to snap that

If you care enuough, i have a spare output you can borrow when you go places far away

Drive shaft & axle u-joints, front short side (drivers side) inner axle, spare hub parts and maybe a spare starter and power steering pump oh yeah oil, power steering fluid, brake fluid, maybe some gear oil, J.B. weld.
Tools to r/r u-joints among various other tools and just to be safe a power steering pulley puller installer a mini torch and solder in case of radiator repair, that’s about all I can think of right now, I'll get back to you if I think of any other consumables parts .

If you plan on driving it home then I would get a spare set of track arm bushings, you'll need new ones soon anyways and they are only $10. Same goes for the radius arm donuts if your running the soft urethane or rubber ones.

If the rear is locked then I'd recomend carrying spare axle shafts. even though it is 31 spline you're running 36's so expect them to pop if they are the factory shafts.

Eric