I am running a scout 2 box and steering shaft on my truck, and am about to change over to full hydro. I was wondering if anyone knew off hand what the spline setup would be so I can use a column pre-splined. PSC said it is either chevy 3/4-30 or 13/16-36 spline, but didnt know definately what it is.

any helps would be appreciated.

Chris

It's one of those two... you'll have to check yours to see what it is.

Can I just take a vernier caliper to measure the output shaft? the 3/4 and the 13/16th are the width of the shaft and the 30 and 36 are the spline count right?

Can I just take a vernier caliper to measure the output shaft? the 3/4 and the 13/16th are the width of the shaft and the 30 and 36 are the spline count right?

Yes you can.