Well I finally found a Waggy axle for my Tacoma. :flipoff2: I am working on cleaning up the housing and I am wondering what would be the best method. I have been using abrasive wheels on the outside with good results. But what should if anything about the inside of the housing and tubes? There is not alot of rust but some, should I have the housing dipped? Or just forget about it?

dude just go to harbor freight and buy a wire weal that ataches to your grinder then go to town getting the rust off, once thats done primer and paint the axle and your set, dont spend to much time and money cleaning it cause where we wheel you cant keep one clean. :skull: