I have a 10 spline front output that is complete with a 1310 (I need to double check) yoke. I also have a spare 1310 yoke for 10 spline.

I think I can fit this into a flat rate box. If I can shipping is like $9 so how about $40 to your door for the output and yoke? $15 to your door for just the yoke?

pic

I have the 4 bolt CV flange on the front of my 205, I would like to go to a standard 1310. I have not pulled the flange off so I dont know how many splines my current front out put is. I was told if was from a 75 1/2 ton chevy. I dont know if the yoke will bolt up or not, I will have to search on that, but if it will work I will buy it from you. Im not sure I want to go to the expense of replacing the entire output shaft. Im not sure what my other option are though.

The later square flange out-put is 30 spline.

I have the 4 bolt CV flange on the front of my 205, I would like to go to a standard 1310. I have not pulled the flange off so I dont know how many splines my current front out put is. I was told if was from a 75 1/2 ton chevy. I dont know if the yoke will bolt up or not, I will have to search on that, but if it will work I will buy it from you. Im not sure I want to go to the expense of replacing the entire output shaft. Im not sure what my other option are though.
Sorry I didnt see this earlier. I thought I had this thread subscribed???

Yours should be 10 spline

http://www.offroaddesign.com/NP205tech.htm

ttt