I'm redoing the long arms on my TJ, and want to know about a truss for a 4 link. I was thinking about getting the BTF truss with cover, but I'm sure I can make one. Question is, will a truss from square tube be strong enough just attached to the tubes?

The BTF one, and the RockKrawler one both use the diff cover/monting points as part of the mount. If I build one like this one (http://www.ruffstuffspecialties.com/catalog/medium-weight-p-117.html) from Ruff Stuff that only attaches to the tubes. This is a TJ Dana 44, with the thinner tubes. THanks. :smokin:

I'm redoing the long arms on my TJ, and want to know about a truss for a 4 link. I was thinking about getting the BTF truss with cover, but I'm sure I can make one. Question is, will a truss from square tube be strong enough just attached to the tubes?

The BTF one, and the RockKrawler one both use the diff cover/monting points as part of the mount. If I build one like this one (http://www.ruffstuffspecialties.com/catalog/medium-weight-p-117.html) from Ruff Stuff that only attaches to the tubes. This is a TJ Dana 44, with the thinner tubes. THanks. :smokin:

Looks like no one replied here.....

We just got a run of these ready to go...

INFORMATION LINK (http://www.polyperformance.com/shop/product.php?productid=16421&cat=758&page=1)

http://www.polyperformance.com/shop/product_image.php?imageid=4853

http://www.polyperformance.com/shop/product_image.php?imageid=4857

How is the small gap between the upper truss and the lower "shim" piece addressed?

How is the small gap between the upper truss and the lower "shim" piece addressed?
I imagine RTV will seal it just fine.

A problem with BTF seems to be getting stuff delivered in a timely fashion. A friend of mine has been waiting for a diff cover for months.

The same friend built his own truss, as he has a press brake. He had to do it over once he measured and plugged into the 4-link calculator (truss was too tall). So if you fab your own do the calculations before fabbing/welding.

A problem with BTF seems to be getting stuff delivered in a timely fashion. A friend of mine has been waiting for a diff cover for months.



BTF... yes I remember the wait. But after a reasonable time, I decided to call them daily. After about a week of that I finally got my stuff. Next time I will order somewhere else.

Now Poly Performance! That's a different story, Excellent service. No wait.

I imagine RTV will seal it just fine.

A problem with BTF seems to be getting stuff delivered in a timely fashion. A friend of mine has been waiting for a diff cover for months.

The same friend built his own truss, as he has a press brake. He had to do it over once he measured and plugged into the 4-link calculator (truss was too tall). So if you fab your own do the calculations before fabbing/welding.

RTV seals it just fine....

Now Poly Performance! That's a different story, Excellent service. No wait.

Thanks for the kind words man.