Does anyone have any pictures of the exhaust set up of 350 conversion on a FJ40? I had ask about the header issue earlier and would like to see examples.

Jason W.

Try searching as we went over this several months ago, I have no pics but mine go from center dump collectors into 1 3" pipe with the wrap under the tranny pan just like some OEM chevys then just past the service panel for the transfer case then back to the OEM muffler location, all above the frame and out of harms way....

im getting my exhaust done friday, 2 seperate 2.5 inch pipes all the way back! ill snap soem shots while its on teh rack if i can! jimMy

I have dual 2.5" pipes tucked up inside of the frame rails and exiting out just forward of the rear shackle. I'll take a few shots this afternoon if I can find my digital camera.

That will be great if you guys can get some pictures and I did do a search and nothing so anyway thanks for your help.

Jason W.

I'm also interested in the pics. Planning to get rid of my over-the -frame headers.

I would prefer a 2 in 1 dumping into a single muffler.

sorry i havent posted pics yet, been busy, ill post em tomorrow afternoon, my exhaust came out sweetly. dual exhaust all the way back 2 mufflers and looks and sounds sweet! jiMMy

here ya go best shot i could get, drove it a whole 20 feet today whoo hoo. jiMMy

Here ya go... standard block hugger headers... 2" pipe, 2 Dynomax Ultra-flo muffs (offset in/out). I kept the turn outs to the side to minimize the dust it kicks up when I'm in a group.

http://www.nctacomas.com/eskimo/exhaust/1.jpg
http://www.nctacomas.com/eskimo/exhaust/2.jpg
http://www.nctacomas.com/eskimo/exhaust/3.jpg
http://www.nctacomas.com/eskimo/exhaust/4.jpg
http://www.nctacomas.com/eskimo/exhaust/5.jpg

I am going to run 2 to 1 on my LT-1....less crap to bang up on the rocks!

Here's a simple 2 to 1 set-up I had done

2nd

Hey Jimmy, I hope you move that rear brakeline so it doesn't
get :nuke: by the new muffler;)

bad angle on the picture, its about a foot and half away from it and can be moved around! jimMy