|
: Wheel bearing size for Dana 61/61 Semi floating axle Mr.N 02-02-2007, 09:55 AM I've the SPicer part numbers, but I can't find these listed anywhere esle on short notice. SO doesn anyone know the following physical sizes of the Dana 60 & 61 Semi Floating axle bearing? Spicer part#'s 566117 Dana 60 565978 Dana 61 I Think the ID is 45mm or 1.774 Mr.N 02-02-2007, 10:02 AM Looks like this is the Timken bearing info, can anyone confrim? Part No: TF01561R Description ... Value Bore Inches ... 1.704 OD Inches ... 3.0376 Outer Race Number ... RP1561FO Part Number Footnote1 ... 140 Special Features Description ... Repair Bearing Type ... NS Width Inches ... 1.32 Typical 9" Large bearing: Part No: RUB1580EBFR Description Value Bore Inches 1.6248 Inner Race Number Nonseparable OD Inches 3.1496 OD MM 80 Part Number Footnote1 130 Special Features Description Locking collar supplied; Overall width with retainer is 1.3370 Type NS Width Inches 1.083 http://www.markwilliams.com/axleBearings.aspx?CategoryID=138 bdicki 02-02-2007, 05:39 PM The SF 60 bearing has no inner race. The rollers ride on the the axle shaft like an 8.8. http://i160.photobucket.com/albums/t182/bdicki/DSC00741.jpg http://i160.photobucket.com/albums/t182/bdicki/DSC00740.jpg bdicki 02-02-2007, 05:52 PM I think that the repair bearing is offset to ride on a different place on the axle. bronco75 02-02-2007, 08:53 PM sure wish you had asked this earlier this week I have one torn a part doing axle seals on wed. I thought about getting some measurments but I didn't. I can tell you it was in a 89 ford e250 club wagon van and the 1561 bearing listed above is what that model calls for. http://img246.imageshack.us/img246/9770/ja1xe7.jpg Mr.N 02-02-2007, 09:10 PM sure wish you had asked this earlier this week I have one torn a part doing axle seals on wed. I thought about getting some measurments but I didn't. I can tell you it was in a 89 ford e250 club wagon van and the 1561 bearing listed above is what that model calls for. http://img246.imageshack.us/img246/9770/ja1xe7.jpg Thanks! SO I want the ID of the Dana 60 shaft; and the OD & Width of a big bearing 9" However I might have the 60 turned down the make a small sholder, say 1.67. But this area of axle is new to me... | |