Tomb Raider
02-14-2007, 08:47 AM
My 60's will be here in a week....so I'm listing my current axles for sale when they come out in the next few weeks.
$850 for the axles.
Front axle is 4.10's with an aussie locker and rockcrusher diff. Has the JB4x4 bracket installed as well for crossover steering. I will include the draglink if you decide you want it all. This is out of my 95YJ. Therefore, these have 297x ujoints in the axle shafts. Yes, the same ujoints as in Dana 44's. The passenger side was replaced about a month ago, I have another for the drivers side which I will replace when the axles are sold.
Rear axle is 8.8 from a 2000 explorer with 89k on it. 4.10's, TracLoc diff and rock crusher diff cover. I have an extra open carrier that will go with it if you decide to put a locker in the back someday. It is currently set up for SOA, but is easily changed. There is no ebrake hardware. This It currently has a traction bar on it, of which I will take off. If you decide to go SOA and want the traction bar, add $200.
Both axles will come with ubolts, plates and nuts/washers. These are all less than 9 months old, and were SOA, so they are not bent in the least.
Here's the breakdown on MY costs on the axles.
Front:
Dana 30 = Free
Aussie locker = $250
Crossover Steering setup = $200
Rock crusher diff cover = $100
Rear:
8.8 = $250
New pads/rotors = $100
New brake lines hard/soft = $50
New MORE perches/ubolts/plates =$140
Rock crusher diff cover = $100
Total cost front/rear not including install and basically "free" d30: $1190
Your cost: $850
http://www.tombraiderjeep.com/jeepin/stretched34.jpg
http://www.tombraiderjeep.com/jeepin/ShowLetter.jpg
$850 for the axles.
Front axle is 4.10's with an aussie locker and rockcrusher diff. Has the JB4x4 bracket installed as well for crossover steering. I will include the draglink if you decide you want it all. This is out of my 95YJ. Therefore, these have 297x ujoints in the axle shafts. Yes, the same ujoints as in Dana 44's. The passenger side was replaced about a month ago, I have another for the drivers side which I will replace when the axles are sold.
Rear axle is 8.8 from a 2000 explorer with 89k on it. 4.10's, TracLoc diff and rock crusher diff cover. I have an extra open carrier that will go with it if you decide to put a locker in the back someday. It is currently set up for SOA, but is easily changed. There is no ebrake hardware. This It currently has a traction bar on it, of which I will take off. If you decide to go SOA and want the traction bar, add $200.
Both axles will come with ubolts, plates and nuts/washers. These are all less than 9 months old, and were SOA, so they are not bent in the least.
Here's the breakdown on MY costs on the axles.
Front:
Dana 30 = Free
Aussie locker = $250
Crossover Steering setup = $200
Rock crusher diff cover = $100
Rear:
8.8 = $250
New pads/rotors = $100
New brake lines hard/soft = $50
New MORE perches/ubolts/plates =$140
Rock crusher diff cover = $100
Total cost front/rear not including install and basically "free" d30: $1190
Your cost: $850
http://www.tombraiderjeep.com/jeepin/stretched34.jpg
http://www.tombraiderjeep.com/jeepin/ShowLetter.jpg