I have found a D60 out of a 90 Dodge. What am I going to get in to putting this in a 80 Chevy? Thanks

I have found a D60 out of a 90 Dodge. What am I going to get in to putting this in a 80 Chevy? Thanks

from what Ive researched, the pads are outboarded like an in or so more than chevy's, no big deal there, and the mounts for the tre's are higher than the ones for chevy knuckles. oh and dodge(all?) use one flex line to the axle and then hardline to calipers. dont know if there is another flexline at that point. hope this helps you out.

the dodge brake hoses will bolt to the chev frame lines, might have to relocate them or just order chev hoses

the spring pads are about an inch wider
the wms to wms on the dodge is about 2" narrower so it tucks tires under the fenders better
wheel studs on the dodge are usually 1/2" vs 9/16" for the chev, chev studs swap

They're also a littler narrow than the chevy D60, and the yoke is different. Check out the D60 bible in the tech section for more good info.