I am wondering what people are running as far as ground-to-frame belly height on their formula toyotas. What springs/tire combo are you using to achieve the height you're at? Thanks for any input.

We have 25in. under the lowest part of the skidplate but we dont have a flat belly. We run 5in. Trail gear springs and Interco Truxus stickeys 37x12.50-17 on Trail gear 17x8 wheels

I have 18" but trying to lower it for better aerodynamics thinking about an air splitter under the front.:flipoff2:



Seriously, I have 25.5", flatbelly, 37 sticky Trxus and 3" AP buggies front and rear. My front hanger is mounted higher than normal and i'll be dropping it to gain more up travel on the front springs which will raise the rig a little. May have to go with 4" springs if this doesn't work out.

23" to the flat belly skid plate which is a 1" and half below my frame rails running 38.5" sx's, and 74" to the top of the cage.

running 48" rear springs upfront and 51" rears flipped backwards in the back.

Seems to be a good height, could probably get away with it a bit lower.

23-1/2 with 20 psi in 37's

15.5 inches sittoing on 31 inch tires

15.5 inches sittoing on 31 inch tires

Hows that thing coming along anyway you havent posted any pics for awhile

Was 27.5" running AP's (Bett's) 4" Springs w/ 37" MTR's

Just installed AP's 3" Buggy springs and it now sits at 25.75". However the COG is a bit lower, but it's flexier than ever :smokin:

some picture here of it
it runs really good even with the strange intake system on it

http://sandlakeduners.com/forum/viewtopic.php?t=22325&start=30

just go down the page a little

Your link requires a username & password. :(