Anyone know the torque specs for the brake caliper bolts for an '05 F-250?

I want to say 36 ft/lb...this is for the caliper pins right? I know the caliper bracket mounting bolts have close too, or more, than 100 ft/lb on them..

Fuck...i get home at around 1:00 PM CST, I can look it up for the exact specs if ya can wait.

Thanks for the reply. I could use the specs on both pins and mounting. My main concern is the mounted bolts, had one come loose on me once.

Thanks for the reply. I could use the specs on both pins and mounting. My main concern is the mounted bolts, had one come loose on me once.

Really fucking tight on the mounting bolts....be sure to use loc-tite!!!!!

I found these:
Caliper pin: 27ft-lbs
Caliper banjo bolt: 37ft-lbs
RW disc brake adapter bolts: 150ft-lbs
RW disc brake sheild bolts: 8ft-lbs
Rotor-hub bolts: 94ft-lbs
Stone shield nuts: 46ft-lbs
Caliper anchor plate bolts: 128ft-lbs
Axle shaft retaining bolts: 80ft-lbs

I usually tighten until it starts to get loose then back off a 1/4 turn.

Great info, thanks! I think it's time to invest in a service manual but couldn't find one in time for this project.

I usually tighten until it starts to get loose then back off a 1/4 turn.

LOL Think we've all been there and done that. :D

At 150 ft/lbs on the caliper mounting bolts I don't think I have a long enough torque wrench to strip them.

Goobs of locktite on these.