I need some info and I know I could go to the j. yard but someone knows this. I need a dana 60 right at or over 70" wms to wms whats it out of?

----------------------------------------------------------------------------------

UPDATE I meant the rear sorry, but I appreciate the info on the fronts as well. What my intentions are is to find the widest rear I could and cut the F.F. spindles off and weld on a set on new billet bearing cups to produce another (I did you prev. but I retubed it) semi float 40 spline rear without having to retube it, That is one mother of a BITCH. I might even be interested in Sandy Cones 46 spline axles I just need to find a housing that once the ends were cut off would produce a housing that the chunk was centered and the tubes were 55" to the ends. Once I add the bearing cups from mark williams they are 2" each would yeild a housing 59" end to end and with ford large ends have a axle standout of 2.500" each side would give me a axle 64" WMS to WMS


Thanks for your help Chris:smokin:

Front or rear? Chevy front 60s are 69" I think

rears

The scissor lift I used at work last week had a D60 ~84" wide. Spool too. :)

I have a Chevy van based motorhome HD 60 I am looking to unload, 35 splines 4.09, and around 73 inches wide

Let me know what you want for it if hes not interested.

anything else close?

98 Dodge 60 front is 71" WMS-WMS but it is also CAD

Chiscouter I emailed you about the axle I am interested in it . It looks like it may be a motorhome , van or, I noticed the majority of street sweepers have centered very wide axles easly in the 70" range, but with my luck non of the above I have access to

Keep Them Coming and thanks so FAR Chris:smokin: