Vortec_Cruiser
04-23-2007, 12:51 PM
Are you guys desmogging your engines, or just leaving them as-is? :)
|
Vortec_Cruiser 04-23-2007, 12:51 PM Are you guys desmogging your engines, or just leaving them as-is? :) rickibrat2 04-23-2007, 01:52 PM OFF ROAD USE only no smog garbage at all a2b 04-23-2007, 02:02 PM yes.:) mtbrjon 04-23-2007, 02:31 PM Yes- desmogged Vortec_Cruiser 04-23-2007, 05:56 PM Does anyone have a writeup on how it is done properly, so the engine still runs well? :) rickibrat2 04-23-2007, 06:39 PM do not know of a write up on how to do it what i did is as follows all EGR passages on exhust side of hears were taped and plugs installed EGR on itake was removed and a cover over the area to seal it off. all sensors from motor were removed and plugs installed dist removed and replaces with a DUI unit [one wire] carb removed and intake adapated ot VW fuel injection [ mech type basic a throttle body style someof this in the near future willbe removed as i am thinking about going to propane but have questions as to if it comes with a special carb or do i have to use the toyota one exhust is handle via a 2 tube header in to 2.5 inch pipe with a turbo tucked up hig to floor and the exhust routed back exiting from reab by the tail light to kee wter outof tail pipe ane motor i hope in case of water crossings :) Vortec_Cruiser 04-27-2007, 03:47 PM Does anyone have some information for doing this on a 22RE with the stock fuel injection system? :) rickibrat2 04-27-2007, 04:03 PM Does anyone have some information for doing this on a 22RE with the stock fuel injection system? :) not sure you can you are going to have to leave all the sensors in place for the computor to see bet you can pull the the computor is going to have to see them egr you can remove i bet but you have to leave the egr senore on the wring at least with ford you do i have convert a lot of ford to late model fuel injection YotaRunner 04-30-2007, 06:17 PM Does anyone have a writeup on how it is done properly, so the engine still runs well? :) Good info for the RE-engins Take a peak through this thread... http://www.pirate4x4.com/forum/showthread.php?t=238808&pp=25 Vortec_Cruiser 04-30-2007, 10:30 PM Good info for the RE-engins Take a peak through this thread... http://www.pirate4x4.com/forum/showthread.php?t=238808&pp=25 That's exactly what I am looking for. Thanks, YotaRunner! :) YotaRunner 04-30-2007, 11:26 PM That's exactly what I am looking for. Thanks, YotaRunner! :) Don't thank me..... Thank Rick! He's about the only one on the board who documents EVERY little trick, mod or creation he dose spite how small or minute it is.... and he shares! | |