I have a 1" daystar polyurethane bodylift that I bought to put on my Jeep and used it only for mock up purposes. The 2 bushings that go in front of the gas tank inside the frame rails have about 1/4" ground off the side 1/2" up to fit in a channel that I was going to use as a crossmember (will not be seen when installed). I was going to use this on my Jeep but now have tied the cage to the frame and no longer need them. All hardware is included Never been on the road, bought from Creeperz laborday weekend. $80 Shipped


I would also trade for '80 scout front or rear axle shafts or 5 on 5.5 x 1.5" wheel spacers.