well i finally picked up a d44 out of a ford from a friend and need to find rims for it and i put a 8 lug off a chevy and went to fit the rim on and the pattern was differnt. now i am wondering if a chevy rotor will fit on the spindle or if they are differnt? ne good ideas >? i am going to run a 14 bolt in the rear

thanx

no ideas n e one?

99 and up ford ran 8-170 bolt pattern not 8-6.5 you can change to chevy knuckles and run 8-6.5 front and rear

how about knuckles of a jeep 80s wagey

are the jeep knuckles flat top? six lug?