Anyone have any recommendations for a 110 rear driveshaft?

Can jesse or someone else build me one? I don't need a cv just a strong driveshaft (does not even have to be strong) or are rover flanges not makeable/cost prohibitive?

I can get a new one for $200ish but . . . thats too easy.

Ron

Ron,

I had the rear driveline made from scratch for the 145, and had the original 127 driveline shortened to fit the front. All of this was for $350, so I think that $200 for a rear is probably pretty fair.

If you want one made that is BEEFY give me some dimensions. I'm going in to pick up my rear RR driveline tomorrow. They can have it built in a week or so.

Just gimme the green light!

Michael

Any driveline shop can make you a rear driveshaft as the flanges are common off the shelf stuff. Since the 110 driveshafts are so long you probably don't need a CV or the associated adapter so just take in a flange for them to match and a measurement of your stock part and they can make one up. You might get a slightly longer slip joint in your new one for a long travel suspension.

thanks for the offer mike.

i have a shop here that can do it, just needed to know if they were common parts

thanks

Ron