|
supervert 06-02-2007, 10:32 PM does anybody have the drawing and measurements for a 300 six. i need to make a adaptor for a 435 to a 2.3 and need better measurements than me with a tape. i allready have the factory drawings for the 2.3 thanks, jeff mondtster 06-02-2007, 11:04 PM try looking for ones for a SBF. I'm pretty sure they share the same bolt pattern. svt150j49 06-03-2007, 01:10 PM its true. the 300 is a small block style. it will bolt in place of any sbf bellhousing, cept the early 289s... gfbgreaser289 06-03-2007, 01:27 PM and also the 221's,255's,260's. these are all 5 bolt pattern 82F100SWB 06-03-2007, 01:52 PM The 255 is 6 bolt, it didn't appear until 1980... supervert 06-03-2007, 08:57 PM yea i figured they were the same. does anybody have the measerments though or does anybody know where i can get them? supervert 06-03-2007, 10:27 PM i found this one but it doesnt have all the measurements. can someone fill in the blanks please? http://i132.photobucket.com/albums/q7/supervert/302dimscan2.jpg supervert 06-04-2007, 09:04 AM heres the 2.3 if anybodys lookin http://i132.photobucket.com/albums/q7/supervert/diagram.jpg | |