Doing an axle swap; got the rear completely out except for the brake lines. Wondering what's the easiest way to disconnect the e-brake and brake lines. Thanks.

Heat, PB blaster, brake line wrench

Diconnect the e-brake cables at the tensioner gadget by loosening it. The cables clip into the frame with a c-clip. So once you have the cable ends loose all you need to do is pop out those c-clips. You can leave the other ends connected at the wheels.

Brakes are SOOO yesterday, nobody runs them anymore

Diconnect the e-brake cables at the tensioner gadget by loosening it. The cables clip into the frame with a c-clip. So once you have the cable ends loose all you need to do is pop out those c-clips. You can leave the other ends connected at the wheels.

Unless you want to reuse them for the new axle. If you pull the drums, you can disconnect them from the lever inside and keep the cables attached to the vehicle for the new axle.

Alright thanks a lot.