im looking at buying a 85 stock 4x4, it comes with a extra set of nice rims with very nice 33" bfgs on them.

i know i would have to cut fender, dont care, chop chop saw saw........ might even get baja fiber glasses.

what i do want to know is will they clear the fire wall and steering box with no lift?

They should clear if you just chop the fenders enough.

If they are a 33x12.50 on 15x8 rim with no backspacing, and it's stock height. It's possible they might rub on sharp turns IMO.

Should be fine. Even if they do rub a little in certain situations (steering locked, front suspension flexed), who cares? Its not going to stop you from getting where you're going.

i was looking at the add again,it not an 85 its an 86 so ifs, change anything?

Should be OK, I have seen people with 32's and no fender trimming.

If it's IFS, you might actually be better off as far as rubbing goes.

From the Toy FAQ:

Stock Toyota front axle measurements for comparison:
55.5" wide, 29" spring perch centers, '79-85 Toyota trucks and 4runners, SA Hubs
58.25" wide, 29" spring perch centers, '79-85 Toyota trucks and 4runners, IFS Hubs
63.5" wide, (set up for coil springs) 90-97 FJ80 and FZJ80 Landcruisers
'86-95 IFS front end is about 58.5" wide
'93-98 T100 IFS front end is about 65" wide