I want to upgrade my rear drive shaft with CV. I'm running the stock dana 300 in my 1982 CJ7. Wich output yoke do I need in the T case (part #)?
Would any Ford or Chevy output yoke work???
I'm in Chile, and Jeep parts right here aren't very popular, so if there's any Chevy or Ford part that works, that will be great
Thanks for you help

Part number is 2-4-4341. Since I see you're from out of the country, I'll give you a tip - it's a Yoke. A Joke is a funny story;)

Good luck

Chuck P

oldjeep, that was a good Yoke !!, Oh I say it wrong againg.....
Thanks for the imput:)

By the way, OLDJEEP, Is that a Spicer part # ???

I believe that it is a spicer part number. here is the source of the information:
http://www.drive-lines.com/4x4s/prices-_Dana/prices-_dana.html

1310 CV Dana 300 T/C
$105.26

:eek: :eek: :eek: :eek: :eek: :eek:
Must be a good yoke....right? :rolleyes: ;)

You can also pull the front yoke off of a XJ 242 t-case. It is a 1310 CV yoke that bolts directly onto the D300 front or rear output. That is the yoke that i have on my D300. Probably cheaper that $100 :D

$59.95 from 4wd hardware.

Quadra-Trac Front Output Shaft Yoke, CJ7, 1976-79
$59.95
Product Number: 244061X

The front Quadra-Trac yoke will fit the front or back of a D300.

Lovin' this place. Just so happens to be the same question I've been tracking down an answer for so I can mount the cut down J20 front shaft in the rear of my almost rolling cj5.

Here's to the guys what answered the question before I could ask it :beer:

Rob:cool2: