I am building a dana 60 and am thinking about putting dana 70 spindles on it so that I do not have to machine out the spindle to make a 35 spline axle go through. The press on spindles are chevy style.

Does anyone know what hubs I need to get? Year and model vehical. :confused:

Does anyone have a good set that they would want to sell?

Why not use 14 bolt ends..they are more common as a std set up (I think that there are too many variation of the 70) for that matter, if this is for a Chevy, why not use the entire 14 bolt?:confused:

It is a Pro Rock 60 from DynaTrac that is going into the rear of a CJ-2A. I talked with DynaTrac and they said they did not think they could get a set of 14 bolt spindles onto thier 3.125" diameter axle tube. 14 bolt spindles is what I initially asked them to put on.

I would guess that you should get hubs that match the spindles.
try for the same axle that you cut the spindles from.
anyone confirm that there are different variations?

Just start with a dana 60 hd and you get 70 outers and 35 spline axels.