FJ40 axles... front and rear.

Front has mini truck harware from the knuckles out (disc brakes/hubs/locking hubs)

Rear axle has GM disc brakes.

Disc conversion (F/R) was done about 3 years ago by the previous owner, and I believe have very little miles on 'em since the truck was torn down for resto not too long after that.

Many thanks if you can help me figure out what they're worth. And if you're interested, they're posted in the FS section.

ttt

Scott,
I assume those are my old axles, must be going 1 ton... Some info on the axles in question. Dogwalker did the disk swap on the front and rear using toy mini birfs., disks, calipers, hubs, etc. on the front; and TSM disk conversion in the rear. The rear was also converted over to fine spline. That's all I can remember for now but if they're not my axles, whoops, to many :beer: !!!

20 bux?!:rasta:

Peabody... thanks for the reply. Yup, those are your axles... I'm going with heavier duty axles.

Good to know the rear is fine spline.... so the front is still coarse spline then?

From the looks of 'em, I'm guessing these are both coarse spline... can someone who knows, tell me for sure?

http://home.4x4wire.com/swilson/temp/for_sale/front.jpg
http://home.4x4wire.com/swilson/temp/for_sale/rear.jpg

Those are Coarse Spline pinions all right.


I would say 400-500 maybe for the pair w\o lockers,kinda depends,you might not even get that much:(

Rob