I've searched but caint find a definitive answer ( I know I've seen it before but when I want the info I can never find it. I know there is a whole article on this swap but I can be a bit of a tard sometimes and caint fnd it ). I'm swapping Dodge dana 60's under my '92 Toy, and am a little stuck on the brakes. Right now I'm running stock 1 ton calipers in front and drums in the rear but going to rear discs next month. I know I want to run a chevy M/C (1" bore?). And I'm planning on using the stock Toy booster and making a adapter plate. My 1'st question is what year truck should I get this M/C off of? 1 ton or 3/4 ton? Next question is should I run new lines down to the center of the dana's to the banjo fitting or run lines seperately to each caliper? I'm not opposed to bending up new brake lines eather way I go but I want to do the most practical of the two. Any body got any pics of what they did for there chevy M/c swaps and how they ran the brake lines? Any other thoughts or suggetions? Damn I'm such a 60 newb still. If I left any info out that is needed post up and I will respond as soon a possible. (Again I know this info is out there but I'm in the middle of moving to a new place and I dont have very much time at all to properly research this so any help is appreciated)