I have just installed a 21 spline AA dual case adapter and i have this part left over and have no idea where it goes. It looks a little like a drain plug but it has approx a 1/2inch hole bored through it. Does anyone have any ideas where it is suposed to go or has someone just thrown this in to confuse me?
There is no mention of this in the destructions or parts list.

Nick are you fu<kin with my head?

Same thing here :confused: I could never figure it out either. I have been running it for a few months with no problems. Anyone?? anyone??

nope, couldn't figure it out either... i just put it back in the box and figured if i needed it i'd at least still have it...

Cool i thought Nick (sikfj40) had put it in there to sh!t me :D

I have to thank Weldpro for supplying this adapter too :flipoff2: :beer:

is it the bolt to fill the 4wd light hole in the donor case?

Ok Here is the deal, you all need to send me that Xtra part........I have a BIG collection of leftover parts when I'm done:D:eek: :eek: :confused: :confused: :p :p :p :p :p

Its a sample end for the speedo cable in case you need to take it to a speedo shop & have an extension made.

RocKrawler you are probably right on there i spent about half an hour looking for where that went. I dont need it then as my speedo is electronic.:beer:

i seriously though about pulling apart out just to shit you, should have done it :flipoff2: :flipoff2:


NICK