Anyone try putting d44 spindle, hubs, rotors, brakes on a d60 kingpin. I am building a front 60 and do not have these parts for a 60 but I have an 8 lug d44 staring at me with all the parts. I am thinking Imight just need a spacer about and inch long or so that mates the 60 knuckle to the d44 spindle. This is for a 30 spline outer which I measured and it was like 1.30" and the chromoly shafts in the d44 I think are 1.18 so the .012" might be too much. I haven't measured bearings and stuff.

A 60 stub will not fit in a 44 spindle.

right parts for the right job and no, they won't work.

:confused:

besids it not working it really would take away the point of having a dana60 in the front... let me try to put a 10bolt gov lock in a ff14bolt.

didnt you already ask this once??