Well I am sure I want to sell the truck. New price 2200

I want to sell the truck with the motor that is rebuilt ready to install. The motor was rebuilt by a local shop in MD where the block and crank were sized .030 over and under. The short block was put together by the machine shop. The motor has an engine builder crawler cam, cleaned fuel injectors, and a new fuel filter. The engine only needs the valves adjusted and installed in the truck for it to run (All wiring and vacuum lines are hooked up to the engine). The truck will also come with a clutch kit to install with the motor. The truck has 150K miles and went through VA inspection before the timing chain on the old motor jump a few teeth and took the valves out. The truck had a minor front end accident so I currently have the front grill and bumper off so I pull the core support out so the radiator would sit in the correct position. The truck has two rust spots, one just above the tail pipe, and right next to the cat. converter on the frame. The rest of the frame seems to be in good shape and only has surface rust on the front because the battery leaked acid at one time. The following parts will also be included front drive shaft for AA crawler, 1.5" ball joint spacers, 84 or 85 front Toyota axle, extra CV shafts, and extra IFS hubs, 32X11.5X15 TSL's pictured on the truck, front crossmember for SAS, 85 Front and Rear leafs, 2002 Tacoma rear leafs with fabtech 2" AAL, 2002 tacoma rotors and calipers which can be used for rear disc brakes, and many spare engine parts.

Pictures
http://home.comcast.net/~paul.trautner/Truckforsale/

http://home.comcast.net/~paul.trautner/Truckforsale/s5030841.jpg