Need TALL D44 arms to get over your spring pack ? Check these out !!

http://www.northwestfab.com/images/steering/441.JPG

Arms are 2.5" Tall for the best spring pack clearace - no spacers required = stock length studs = reduced stud sheer.

We mill the arms with the knuckle inclination angle in mind - the tie rod mounting surface sits level when installed, reducing static steering angles.

http://www.northwestfab.com/images/steering/442.JPG

-4th hole compatable for ultimate use with Solid Axle and Dedenbear aftermarket knuckles!

Tapered for Tie Rod Ends or Drilled For 3/4" Heims.

http://www.northwestfab.com/images/steering/443.JPG

Cut from Billet Steel - A Photo of our CNC Vertical Mill In Action

http://www.northwestfab.com/images/D44CNCt.JPG


We also sell a 9 pc Install kit, 3 Chromoly Studs, 3 Cones and 3 Stover nuts for $29.

The Arms are $149ea, Pair $295.

We also offer crossover and Hi-Steer Kits:

Crossover Kit Includes:
1 pc Passenger Side Steering Arm
1 pc Drop Pitman Arm
1 pc 1.25x.025" DOM Draglink
2 pc Tie Rod Ends,
2 pc Jam Nuts
Crossover Kit $399.00, We recommend adding our chromoly install kit for $29.

Hi-Steer Kit Includes:
1 pc Passenger Side Steering Arm
1 pc Drivers Side Steering Arm
1 pc Drop Pitman Arm
1 pc 1.25x.025" DOM Draglink
1 pc 1.25x.025" DOM Tie Rod
4 pc Tie Rod Ends,
4 pc Jam Nuts
2 Installation Kits
Hi-Steer Kit Crossover Kit $759.00


-Kyle
NWF

Bump, TTT !

Just finished another batch of these ! Good for stock.

Thats an idea that makes sense!

Thats an idea that makes sense!

Thanks Dan !

A new batch just finished in the mill! Give us a call at the shop and get your hi-steer on!