mud_slinga
09-02-2007, 08:24 PM
I just got done putting these on a friends ZJ tonight
http://img.photobucket.com/albums/v314/rock_crawler/Maxxs%20stuff/DSC03281.jpg
The side and plate undernieth the coil trap is 1/4", stitch welded to the unibody(badly, yes I know :flipoff2:). Then the gusset from the bottom 1/4" plate that runs down the subframe. What else could I do to strengthen this area up? I am just concerned since it is trapping the coil, instead of just letting the coil rest there, like a factory mount. Any Ideas would be great, even if it is to take it out and start over. :homer:
http://img.photobucket.com/albums/v314/rock_crawler/Maxxs%20stuff/DSC03281.jpg
The side and plate undernieth the coil trap is 1/4", stitch welded to the unibody(badly, yes I know :flipoff2:). Then the gusset from the bottom 1/4" plate that runs down the subframe. What else could I do to strengthen this area up? I am just concerned since it is trapping the coil, instead of just letting the coil rest there, like a factory mount. Any Ideas would be great, even if it is to take it out and start over. :homer: